SH1B-62

IDEC  SH1B-62  继电器插座, 电路板安装, 10A, 250V, 5针

10 A, 300 V Voltage Rating, 5 Number of Pins, Sockets

Snap-mount sockets are designed to mount on BNDN-1000 mounting rail. The built-in mounting clip eliminates mounting hardware and reduces mounting time by eighty percent. For spacing between adjoining sockets, use SA-406 DIN rail spacer. Spacers

.

* :** 0.197" in width. Spacing can be adjusted according to the amount of spacers added. To prevent sideward movement, use BNL-5 end clip at each end of socket row.

**

To Mount:

.

* Place socket on mounting rail and press down.

**

To Remove:

.

* Pull clip out with screwdriver and lift socket.

SH and SY series panel mount sockets are designed to mount collectively in panel cut-outs. Insert socket with mounting springs facing the top and bottom edge of the panel cut-out. Push the socket until the mounting spring clips onto the panel. See Figure 1.