MCB1850UME

LPC1850 Microcontroller Starter Kit 12MHz/180MHz CPU 16.195Mb RAM 16KB/4Mb/16Mb I2C EEPROM/NOR Flash/SPI Flash

is a Keil MCB1800 evaluation board with ULINK-ME debug adapter. Board enables to create and test working programs based on the NXP LPC1850 ARM Cortex-M3 processor based device. The NXP LPC1850 microcontroller provided with the MCB1800 board is a high end LPC devices with on chip CAN, Ethernet, USB full and high-speed connectivity. A 12MHz oscillator provides the clock signal for the MCU. The JTAG/Cortex debug Interface connector provides debugging and emulator support for the LPC1850 device. The JTAG/Cortex debug Interface allows application debugging and programming of on chip and off chip flash devices. And also supports the Serial Wire Mode of Cortex-M3 based devices. The MCB1800 board connects the on chip serial UARTs to the ST3232C, which converts the logic signals to RS232 voltage levels. ULINK-ME debug adapter connects PC"s USB port to target system and allows to program and debug embedded programs on target hardware.

.

180MHz ARM Cortex-M3 processor based MCU in LBGA256

.

On chip SRAM 200KB

.

On board memory of 16MB NOR flash, 4MB Quad SPI flash, 16MB SDRAM, and 16KB EEPROM I2C

.

Colour QVGA TFT LCD with touch screen

.

10/100 Ethernet port

.

High speed USB 2.0 Host/Device/OTG interface, Full speed USB 2.0 Host/Device interface

.

CAN interfaces, serial/UART port, MicroSD card interface

.

Audio CODEC with line In/Out and microphone/headphone connector + speaker

.

Analog voltage control for ACD input

.

20 pin JTAG, 10 pin Cortex debug, 20 pin Cortex debug + ETM trace