AM29F080B-120SC
NOR Flash Parallel 5V 8M-bit 1M x 8 120ns 44Pin SO
GENERAL DESCRIPTION
The Am29F080B is an 8 Mbit, 5.0 volt-only Flash memory organized as 1,048,576 bytes. The 8 bits of data
appear on DQ0–DQ7. The Am29F080B is offered in 40-pin TSOP and 44-pin SO packages. This device is
designed to be programmed in-system with the standard system 5.0 volt VCCsupply. A 12.0 volt VPPis not required for program or erase operations. The device can also be programmed in standard EPROM programmers.
DISTINCTIVE CHARACTERISTICS
■5.0 V ±10%, single power supply operation
— Minimizes system level power requirements
■Manufactured on 0.32 µm process technology
— Compatible with 0.5 µm Am29F080 device
■High performance
— Access times as fast as 55 ns
■Low power consumption
— 25 mA typical active read current
— 30 mA typical program/erase current
— 1 µA typical standby current standard access time to active mode
■Flexible sector architecture
— 16 uniform sectors of 64 Kbytes each
— Any combination of sectors can be erased.
— Supports full chip erase
— Group sector protection:
A hardware method of locking sector groups to prevent any program or erase operations within that sector group
Temporary Sector Group Unprotect allows code changes in previously locked sectors
■Embedded Algorithms
— Embedded Erase algorithm automatically preprograms and erases the entire chip or any combination of designated sectors
— Embedded Program algorithm automatically writes and verifies bytes at specified addresses
■Minimum 1,000,000 program/erase cycles per sector guaranteed
■20-year data retention at 125°C
— Reliable operation for the life of the system
■Package options
— 40-pin TSOP
— 44-pin SO
■Compatible with JEDEC standards
— Pinout and software compatible with single-power-supply Flash standard
— Superior inadvertent write protection
■Data# Polling and toggle bits
— Provides a software method of detecting program or erase cycle completion
■Ready/Busy# output RY/BY#
— Provides a hardware method for detecting program or erase cycle completion
■Erase Suspend/Erase Resume
— Suspends a sector erase operation to read data from, or program data to, a non-erasing sector, then resumes the erase operation
■Hardware reset pin RESET#
— Resets internal state machine to the read mode
■Command sequence optimized for mass storage
— Specific addresses not required for unlock cycles