AM29F080B-120SC

NOR Flash Parallel 5V 8M-bit 1M x 8 120ns 44Pin SO

GENERAL DESCRIPTION

The Am29F080B is an 8 Mbit, 5.0 volt-only Flash memory organized as 1,048,576 bytes. The 8 bits of data

appear on DQ0–DQ7. The Am29F080B is offered in 40-pin TSOP and 44-pin SO packages. This device is

designed to be programmed in-system with the standard system 5.0 volt VCCsupply. A 12.0 volt VPPis not required for program or erase operations. The device can also be programmed in standard EPROM programmers.

DISTINCTIVE CHARACTERISTICS

■5.0 V ±10%, single power supply operation

— Minimizes system level power requirements

■Manufactured on 0.32 µm process technology

— Compatible with 0.5 µm Am29F080 device

■High performance

— Access times as fast as 55 ns

■Low power consumption

— 25 mA typical active read current

— 30 mA typical program/erase current

— 1 µA typical standby current standard access time to active mode

■Flexible sector architecture

— 16 uniform sectors of 64 Kbytes each

— Any combination of sectors can be erased.

— Supports full chip erase

— Group sector protection:

    A hardware method of locking sector groups to prevent any program or erase operations within that sector group

    Temporary Sector Group Unprotect allows code changes in previously locked sectors

■Embedded Algorithms

— Embedded Erase algorithm automatically preprograms and erases the entire chip or any combination of designated sectors

— Embedded Program algorithm automatically writes and verifies bytes at specified addresses

■Minimum 1,000,000 program/erase cycles per sector guaranteed

■20-year data retention at 125°C

— Reliable operation for the life of the system

■Package options

— 40-pin TSOP

— 44-pin SO

■Compatible with JEDEC standards

— Pinout and software compatible with single-power-supply Flash standard

— Superior inadvertent write protection

■Data# Polling and toggle bits

— Provides a software method of detecting program or erase cycle completion

■Ready/Busy# output RY/BY#

— Provides a hardware method for detecting program or erase cycle completion

■Erase Suspend/Erase Resume

— Suspends a sector erase operation to read data from, or program data to, a non-erasing sector, then resumes the erase operation

■Hardware reset pin RESET#

— Resets internal state machine to the read mode

■Command sequence optimized for mass storage

— Specific addresses not required for unlock cycles