CSD86350Q5DEVM-604

TEXAS INSTRUMENTS  CSD86350Q5DEVM-604  评估模块, 同步降压转换器

The evaluation module is a synchronous buck converter featuring "s NexFET power block technology to provide a high current, ultra high density power supply solution. The evaluation module provides a 1.2V output at 25A from a 12V nominal input bus at over 92% efficiency. The evaluation module is designed to operate from a single supply, so no additional bias voltage is required. The evaluation module uses the TPS51218 high performance, mid input voltage, synchronous buck controller and TI"s NexFET power block to optimize the efficiency and power density of the total solution. The evaluation module provides two test points for measuring the output voltage generated by the module. This allows the user to measure the actual output voltage without losses from output cables and connectors.

.

Input voltage rating from 8V to 13V

.

Output voltage is 1.2V

.

25A steady state load current

.

Switching frequency is about 290kHz

.

Simple access to IC features including enable, power good, and switching node

.

Convenient test points for simple, non invasive measurements of converter performance

It is important to operate this EVM within the input voltage range of 8V to 13V and the output voltage range of no greater than 1.9V. Exceeding the specified input range may cause damage to the EVM.