AD5751
工业电流/电压输出驱动器 Industrial Current/Voltage Output Driver
Product Details
The is a single-channel, low cost, precision, voltage/current output driver with hardware or software programmable output ranges. The software ranges are configured via an SPI-/MICROWIRE™-compatible serial interface. The AD5751 targets applications in PLC and industrial process control. The analog input to the AD5751 is provided from a low voltage, single-supply digital-to-analog converter DAC and is internally conditioned to provide the desired output current/voltage range.
The output current range is programmable across three current ranges: 0 mA to 20 mA, 0 mA to 24 mA, or 4 mA to 20 mA.
Voltage output is provided from a separate pin that can be configured to provide 0 V to 5 V, 0 V to 10 V, and 0 V to 40 V output ranges. An overrange is available on the voltage ranges.
Analog outputs are short-circuit and open-circuit protected and can drive capacitive loads of 1 μF and inductive loads of 0.1 H.
The device is specified to operate with a power supply range from 10.8 V to 55 V. Output loop compliance is 0 V to AVDD − 2.75 V.
The flexible serial interface is SPI and MICROWIRE compatible and can be operated in 3-wire mode to minimize the digital isolation required in isolated applications. The interface also features an optional PEC error checking feature using CRC-8 error checking, useful in industrial environments where data communication corruption can occur.
The device also includes a power-on reset function ensuring that the device powers up in a known state 0 V or tristate and an asynchronous CLEAR pin that sets the outputs to zero-scale/midscale voltage output or the low end of the selected current range.
An HW SELECT pin is used to configure the part for hardware or software mode on power-up.
**Applications**
- .
- Process control
- .
- Actuator control
- .
- PLCs
### Features and Benefits
- .
- Current output ranges: 0 mA to 20 mA, 0 mA to 24 mA, or 4 mA to 20 mA
- .
- ±0.03% FSR typical total unadjusted error TUE
- .
- ±5 ppm/°C typical output drift
- .
- 2% overrange
- .
- Voltage output ranges: 0 V to 5 V, 0 V to 10 V, 0 V to 40 V
- .
- ±0.02% FSR typical total unadjusted error TUE
- .
- ±3 ppm/°C typical output drift
- .
- Overrange capability on all ranges
- .
- Flexible serial digital interface
- .
- On-chip output fault detection
- .
- PEC error checking
- .
- Asynchronous CLEAR function
- .
- Power supply range
- .
- AVDD: 12 V ± 10% to 55 V maximum
- .
- Output loop compliance to AVDD − 2.75 V
- .
- Temperature range: −40°C to +105°C
- .
- 32-lead 5 mm × 5 mm LFCSP package