MAX17085BETL+

集成式充电器，双主降压型控制器和双LDO稳压器 Integrated Charger, Dual Main Step-Down Controllers, and Dual LDO Regulators

The is an integrated charger, dual main step-down controller and dual LDO regulator in 40 pin TQFN package. It is an all-in-one notebook power solution integrating a multichemistry battery charger, dual fixed output Quick-PWM step-down controllers and dual keep-alive linear regulators. The high-frequency 1.4MHz multichemistry battery charger uses a current-mode, fixed inductor current ripple architecture. Low-offset sense amplifiers allow the use of low-value sense resistors for charging and input current limit. The dual Quick-PWM step-down controllers with synchronous rectification generate the 5V and 3.3V main power in a notebook. Low side MOSFET sensing provides a simple low-cost, highly efficient valley current-limit protection. An internal 5V/100mA LDO5 with switchover can be used to either generate the 5V bias needed for power-up or other lower power "always-on" suspend supplies. Another 3.3V/50mA LDO3 provides "always-on" power to a system microcontroller.

.

AC adapter overvoltage and overcurrent protection

.

Operating temperature range from -40°C to 85°C

.

Dual quick PWM with fast transient response and extended on-time

.

Switching frequency is 300KHz to 800KHz

.

Low noise ultrasonic mode

.

Autoretry fault protection

.

Automatic selection of system power source

.

Internal charge pump for adapter n-channel MOSFETs drive

.

Monitor o/ps for AC adapter current ±2% accuracy, battery discharge current ±2% accuracy

.

Analogue/PWM 100Hz to 500KHz adjustable charge current setting