PCA9516APW

5通道I2C总线集线器 5-channel I2C-bus hub

Overview

The PCA9516A is a CMOS integrated circuit intended for application in I²C-bus and SMBus systems.

While retaining all the operating modes and features of the I²C-bus system, it permits extension of the I²C-bus by buffering both the data SDAn and the clock SCLn lines, thus enabling five buses of 400 pF.

The I²C-bus capacitance limit of 400 pF restricts the number of devices and bus length. Using the PCA9516A enables the system designer to divide the bus into five segments off of a hub where any segment-to-segment transition sees only one repeater delay.

It can also be used to run different buses at 5 V and 3.3 V or 400 kHz and 100 kHz buses where the 100 kHz bus is isolated when 400 kHz operation of the other bus is required.

**Two or more**PCA9516A**s cannot be put in series.**The PCA9516A design does not allow this configuration. Since there is no direction pin, slightly different "legal" low voltage levels are used to avoid lock-up conditions between the input and the output of each repeater in the hub. A "regular LOW" applied at the input of a PCA9516A will be propagated as a "buffered LOW" with a slightly higher value on all the enabled outputs. When this "buffered LOW" is applied to another PCA9515A, PCA9516A, or PCA9518A in series, the second PCA9515A, PCA9516A, or PCA9518A will not recognize it as a "regular LOW" and will not propagate it as a "buffered LOW" again. The PCA9510A/9511A/9513A/9514A and PCA9512A cannot be used in series with the PCA9515A, PCA9516A, or PCA9518A, but can be used in series with themselves since they use shifting instead of static offsets to avoid lock-up conditions.

MoreLess

## Features

* 5 channel, bidirectional buffer

* I²C-bus and SMBus compatible

* Active HIGH individual repeater enable input

* Open-drain input/outputs

* Lock-up free operation

* Supports arbitration and clock stretching across the repeater

* Accommodates Standard-mode and Fast-mode I²C-bus devices and multiple masters

* Powered-off high-impedance I²C-bus pins

* Operating supply voltage range of 2.3 V to 3.6 V

* 5.5 V tolerant I²C-bus and enable pins

* 0 Hz to 400 kHz clock frequency1

* ESD protection exceeds 2000 V HBM per JESD22-A114, 200 V MM per JESD22-A115, and 1000 V CDM per JESD22-C101

* Latch-up testing is done to JEDEC Standard JESD78 which exceeds 100 mA

* Packages offered: SO16 and TSSOP16

1\\. The maximum system operating frequency may be less than 400 kHz because of the delays added by the repeater.

## Features