LPC-P2378

开发板和工具包 - ARM DEV BRD FOR LPC2378 512KB FLASH 16KB RAM

The is an development prototype board for LPC2378, an ARM7TDMI-S based high performance 32bit RISC microcontroller with thumb extensions, 512KB on chip flash ROM with in system programming ISP and in application programming IAP, 58KB RAM, CPU clock up to 72 MHz, on chip crystal oscillator, on chip 4MHz RC oscillator, On chip PLL. Enhanced vectored interrupt controller, Ethernet 10/100 MAC with DMA, external memory controller for static devices such as flash and SRAM, USB 2.0 full speed device controller, CAN 2.0B with two channels, general purpose DMA controller, four UARTs, one with full modem interface, three I2C serial interfaces, Three SPI/SSP serial interfaces, I2S interface, SD/MMC memory card interface, 10bit ADC with 8 channels, 10bit DAC, four 32bit timers with capture/compare, watchdog timer, PWM unit for three phase motor control, real time clock with optional battery backup, brown out detect circuit, general purpose I/O pins.

.

Standard JTAG connector with ARM 2x10pin layout for programming/debugging with ARM-JTAG

.

Ethernet 100MBit

.

CAN driver and connector

.

SD/MMC card connector

.

UEXT connector with I2C, SPI, RS232 and power supply for connecting add on modules like RF link, MP3

.

Reset circuit with external control of Philips ISP utility via RS 232 port

.

Jumpers for ISP/RUN mode

.

Two on board voltage regulators 3V and 5V with up to 800mA current

.

Extension port connector for many of microcontrollers pins

.

Single power supply External power supply, USB or JTAG connector