ST72F521AR9T3

64分之80 -PIN 8位MCU 32到60K闪存/ ROM ， ADC ， 5个定时器， SPI ， SCI ， I2C ， CAN接口 80/64-PIN 8-BIT MCU WITH 32 TO 60K FLASH/ROM, ADC, FIVE TIMERS, SPI, SCI, I2C, CAN INTERFACE

INTRODUCTION

The ST72F521 and ST72521B devices are members of the ST7 microcontroller family designed for mid-range applications with a CAN bus interface Controller Area Network.

All devices are based on a common industry standard 8-bit core, featuring an enhanced instruction set and are available with FLASH or ROM program memory.

■ Memories

– 32K to 60K dual voltage High Density Flash HDFlash or ROM with read-out protection capability. In-Application Programming and In-Circuit Programming for HDFlash devices

– 1K to 2K RAM

– HDFlash endurance: 100 cycles, data retention: 20 years at 55°C

■ Clock, Reset And Supply Management

– Enhanced low voltage supervisor LVD for main supply and auxiliary voltage detectorAVD with interrupt capability

– Clock sources: crystal/ceramic resonator oscillators, internal RC oscillator and bypass for external clock

– PLL for 2x frequency multiplication

– Four power saving modes: Halt, Active-Halt, Wait and Slow

■ Interrupt Management

– Nested interrupt controller

– 14 interrupt vectors plus TRAP and RESET

– Top Level Interrupt TLI pin

– 15 external interrupt lines on 4 vectors

■ Up to 64 I/O Ports

– 48 multifunctional bidirectional I/O lines

– 34 alternate function lines

– 16 high sink outputs

■ 5 Timers

– Main Clock Controller with: Real time base, Beep and Clock-out capabilities

– Configurable watchdog timer

– Two 16-bit timers with: 2 input captures, 2 out put compares, external clock input on one timer, PWM and pulse generator modes

– 8-bit PWM Auto-Reload timer with: 2 input captures, 4 PWM outputs, output compare and time base interrupt, external clock with event detector

■ 4 Communications Interfaces

– SPI synchronous serial interface

– SCI asynchronous serial interface

–I2C multimaster interface SMbus V1.1 compliant

– CAN interface 2.0B Passive

■ Analog periperal low current coupling

– 10-bit ADC with 16 input robust input ports

■ Instruction Set

– 8-bit Data Manipulation

– 63 Basic Instructions

– 17 main Addressing Modes

– 8 x 8 Unsigned Multiply Instruction

■ Development Tools

– Full hardware/software development package

– In-Circuit Testing capability