LT3042EMSE#PBF
LINEAR TECHNOLOGY LT3042EMSE#PBF 电压稳压器, LDO, 可调, 1.8V至20V输入, 350mV压差, 0V至15V/0.2A输出, MSOP-10
The is a 200mA High Performance RF Linear Regulator featuring ultralow noise and ultrahigh PSRR architecture for powering noise sensitive RF applications. Designed as a precision current reference followed by a high performance voltage buffer, this can be easily paralleled to further reduce noise, increase output current and spread heat on the PCB. The LT3042"s wide output voltage range 0 to 15V while maintaining unity-gain operation provides virtually constant output noise, PSRR, bandwidth and load regulation, independent of the programmed output voltage. Additionally, the regulator features programmable current limit, fast start-up capability and programmable power good to indicate output voltage regulation. The LT3042 is stable with a minimum 4.7µF ceramic output capacitor. Built-in protection includes reverse battery protection, reverse current protection, internal current limit with fold back and thermal limit with hysteresis.
- .
- Ultralow RMS noise 0.8µVRMS, 10Hz to 100kHz
- .
- Ultralow spot noise 2nV/√Hz at 10kHz
- .
- Ultrahigh PSRR 79dB at 1MHz
- .
- Single capacitor improves noise and PSRR
- .
- ±1% Initial accuracy 100µA SET pin current
- .
- Single resistor programs output voltage
- .
- High bandwidth 1MHz
- .
- Programmable current limit
- .
- Low dropout voltage
- .
- Programmable power good
- .
- Fast start-up capability
- .
- Precision enable/UVLO
- .
- Parallel able for lower noise and higher current
- .
- Internal current limit with fold back
- .
- 4.7µF Ceramic minimum output capacitor
- .
- Reverse battery and reverse current protection