锐单电子商城 , 一站式电子元器件采购平台!
  • 电话:400-990-0325

PCA9535CPW,118

PCA9535 系列 16-位 I2C-总线 / SMBus 低功耗 I/O 端口 带中断 - TSSOP 24

Overview

The PCA9535 and PCA9535C are 24-pin CMOS devices that provide 16 bits of General Purpose parallel Input/Output GPIO expansion for I²C-bus/SMBus applications and was developed to enhance the Semiconductors family of I²C-bus I/O expanders. The improvements include higher drive capability, 5 V I/O tolerance, lower supply current, individual I/O configuration, and smaller packaging. I/O expanders provide a simple solution when additional I/O is needed for ACPI power switches, sensors, push buttons, LEDs, fans, etc.

The PCA9535 and PCA9535C consist of two 8-bit Configuration Input or Output selection, Input, Output and Polarity Inversion active HIGH or active LOW operation registers. The system master can enable the I/Os as either inputs or outputs by writing to the I/O configuration bits. The data for each input or output is kept in the corresponding Input or Output register. The polarity of the read register can be inverted with the Polarity Inversion register. All registers can be read by the system master. Although pin-to-pin and I²C-bus address compatible with the PCF8575, software changes are required due to the enhancements and are discussed in _Application Note AN469_.

The PCA9535 is identical to the PCA9555 except for the removal of the internal I/O pull-up resistor which greatly reduces power consumption when the I/Os are held LOW.

The PCA9535C is identical to the PCA9535 except that all the I/O pins are high-impedance open-drain outputs.

The PCA9535 and PCA9535C open-drain interrupt output is activated when any input state differs from its corresponding Input Port register state and is used to indicate to the system master that an input state has changed. The power-on reset sets the registers to their default values and initializes the device state machine.

Three hardware pins A0, A1, A2 vary the fixed I²C-bus address and allow up to eight devices to share the same I²C-bus/SMBus. The fixed I²C-bus address of the PCA9535 and PCA9535C are the same as the PCA9555 allowing up to eight of these devices in any combination to share the same I²C-bus/SMBus.

MoreLess

## Features

* Operating power supply voltage range of 2.3 V to 5.5 V

* 5 V tolerant I/Os

* Polarity Inversion register

* Active LOW interrupt output

* Low standby current

* Noise filter on SCL/SDA inputs

* No glitch on power-up

* Internal power-on reset

* 16 I/O pins which default to 16 inputs

* 0 Hz to 400 kHz clock frequency

* ESD protection exceeds 2000 V HBM per JESD22-A114, 200 V MM per JESD22-A115, and 1000 V CDM per JESD22-C101

* Latch-up testing is done to JEDEC Standard JESD78 which exceeds 100 mA

* Offered in four different packages: SO24, TSSOP24, HVQFN24 and HWQFN24

## Features

PCA9535CPW,118 PDF数据文档
图片 型号 厂商 下载
PCA9535CPW,118 NXP 恩智浦
PCA9554PW NXP 恩智浦
PCA9554D,118 NXP 恩智浦
PCA9548APW NXP 恩智浦
PCA9517D TI 德州仪器
PCA9306DCTR TI 德州仪器
PCA9306DCUR TI 德州仪器
PCA9306DCUT TI 德州仪器
PCA9600DP,118 NXP 恩智浦
PCA9541APW/03,112 NXP 恩智浦
PCA9545APW TI 德州仪器