PIC-P28-USB

DEVELOPMENT BOARD FOR 28Pin PIC MICROCONTROLLERS WITH USB-RS232 CONVERTER; External Height: 80mm; External Width: 100...

The is a ICSP/ICD enabled 28pin PIC microcontroller prototype board with USB. With this board you can develop and prototype any 28pin PIC microcontrollers. This board was designed to allow easy interfacing of embedded projects to computers with USB. F232 USB to RS 232 converter IC creates virtual COM port to the PC and you can easily send and receive date using the good old fashioned RS 232 interface in the PIC microcontroller. The on board ICSP connector allow you to program the PIC on theboard without pulling it of the socket, by ICSP programmer like PICMCP, PIC-MCP-USB, PIC-PG1, PIC-PG2, PIC-PG3, PIC-PG4 or to program and debug it with PIC-ICD2, PIC-ICD2-POCKET or PIC-ICD2-TINY. The oscillator circuit is made with 20 MHz crystal oscillator, so you can run your PIC at maximum performance.

.

USB to RS 232 FT232 converter

.

I2C EEPROM socket

.

Takes power from USB no need for external adapter

.

Power supply filtering capacitors

.

Quartz crystal oscillator circuit 20MHz

.

Selectable 3.3V/5V power supply voltage regulator

.

General purpose push button connected to RA5

.

Status LED connected to RA2 via removable jumper

.

DIL28 microcontroller socket

.

Four mounting holes 3.3mm

All programmers provide power supply through ICSP connector during the programming PIC-P28-USB should not be connected to USB. Of course PIC-ICD2 have option to not power the target circuit.