76385-305LF

AMPHENOL FCI  76385-305LF.  针座, 10路 双排

The DUBOX 76385 series Connector families offer an extensive range of through-hole and surface-mount part options, including either straight or right angle orientation from 2 to 50 positions, with a current rating of 3A maximum per individual contact. The Dubox® contact has a pre-stressed, dual beam design to enable low insertion force, 4-wall contact design for signal protection. These are applicable in electronic equipment or devices requiring a parallel, planar or perpendicular board-to-board, wire to-board or flat cable interconnects. Uses span industry segments.

.

Dual beam contact design

.

Contact pre-stressed

.

Mates with very short pins 5mm stackable end-to-end and side-by-side

.

Floating solder tails self centre on the circuit pads

.

4 wall contact design

.

Duplex plating

.

High reliable electrical performances

.

Low insertion force required

.

Meets your specific needs and is useful for Mezzanine Application

.

Easy to assures the coplanarity

.

Signal protection

.

Maintaining the alignment for soldering and facilitates robotic placement

.

Compatible with infrared and vaporphase reflow