MAX406AESA+T

运算放大器, 1个放大器, 8 kHz, 5 V/ms, 2.5V 至 10V, NSOIC, 8 引脚

The from Products is a single supply, single operational amplifier op-amp in 8 pin NSOIC package. This low voltage, micropower, precision op-amp is designed for battery operated systems. The single supply device features a supply current of less than 1.2µA per amplifier that is relatively constant over entire supply range which represents 15 to 20 times improvement over industry standard micropower op-amp. A unique output stage enables this op-amp to operate at ultra-low supply current while maintaining linearity under loaded conditions. In addition, output is capable of sourcing 1.8mA when powered by 9V battery. The MAX406A is a single op-amp with two modes of operation such as compensated mode and decompensated mode. Floating BW pin 8 or connecting it to V- internally compensates amplifier. This device is used in intrinsically safe systems, electrometer amplifiers, photodiode pre-amps and pH meters, battery powered and medical instruments.

.

Supply voltage range is 2.5V to 10V, 1.2µA maximum quiescent current per amplifier

.

Operating temperature range from -40°C to 85°C

.

Maximum offset voltage is 500µV at TA= +25°C V+=2.5V

.

Typical input bias current is < 0.1pA at TA= +25°C V+=2.5V

.

Input voltage range includes negative rail, output swings rail to rail

.

Large signal voltage gain of 1000V/mV at Vout = ±2V

.

Typical unity-gain stable with a 5V/ms slew rate at TA= +25°C V+=2.5V, compensated mode

.

Typical CMRR value is 80dB and PSRR value is 50µV/V at TA=+25°C V+=2.5V

.

Typical gain bandwidth is 8KHz compensated mode and 40KHz decompensated mode at TA= +25°C

.

Battery-Powered Systems; Cordless Phones; Electrometer Amplifiers; Glucose Meters; GPS Solutions; Intrinsically Safe Systems;

.

IP Camera; Medical Instruments; Panel Meters; pH Meters; Photodiode Pre-Amps; Power Meters; Programmable Logic Controllers PLCs