ATSAML21E15B-MUT

ATMEL  ATSAML21E15B-MUT  微控制器, 32位, SMART SAML21, ARM 皮质-M0+, 48 MHz, 32 KB, 4 KB, 32 引脚, QFN

The is a smart ARM based 32bit microcontroller 32 pin QFN package. This SMART SAML21 series of ultra low power microcontroller using 32bit ARM Cortex -M0+ processor, operate at maximum of 48MHz and reach 2.46 CoreMark/MHz. It has flash memory up to 32KB and 4KB of SRAM. It is designed for simple, intuitive migration with identical peripheral modules, hex compatible code, identical linear address map and pin compatible migration paths between all devices. It includes intelligent and flexible peripherals, Atmel event system for inter peripheral signalling and support for capacitive touch button, slider and wheel user interfaces. It has an in-system programmable flash, 16-channel direct memory access DMA controller, 12-channel event system, programmable interrupt controller, up to 25 programmable I/O pins, power-on reset POR and brown-out detection BOD, internal and external clock options, external interrupt controller EIC, 32bit real time clock and calendar.

.

Operating voltage range from 1.62V to 3.63V

.

Operating temperature range from -40°C to 85°C

.

3 timer counter TC, 2 waveform output channels per TC & 3 timer counter for control TCC

.

16 external interrupt lines, 1 USB interface, 6 SERCOM & 4 configurable custom logic CCL LUTs

.

10 ADC, 2 analogue comparators, 2 DAC, 3 op-amp and 1 AES engine

.

Real time counter RTC, 1 RTC alarm and one 32bit /two 16bit RTC compare values

.

42 7 x 6 peripheral touch controller PTC channels X- x Y-lines for mutual capacitance

.

Two-pin serial wire debug SWD programming, test and debugging interface

.

Low power modes idle, standby, backup, off sleep, sleepwalking peripherals, battery backup support

.

Supported by Atmel studio, Atmel software framework and SAM L21 Xplained pro kit