AD5748

用可编程范围工业电流/电压输出驱动器 Industrial Current/Voltage Output Driver with Programmable Ranges

Product Details

The is a single-channel, low cost, precision, voltage/ current output driver with hardware or software programmable output ranges. The software ranges are configured via an SPI-/ MICROWIRE™-compatible serial interface. The AD5748 targets applications in PLC and industrial process control. The analog input to the AD5748 is provided from a low voltage, single-supply, digital-to-analog converter DAC and is internally conditioned to provide the desired output current/voltage range. The analog input range is 0 V to 4.096 V.

 

The output current range is programmable across two current ranges: 4 mA to 21 mA and 0 mA to 21 mA.

Voltage output is provided from a separate pin that can be configured to provide 0 V to 5 V, 0 V to 10.5 V, or ±10.5 V output range.

Analog outputs are short-circuit and open-circuit protected and can drive capacitive loads of 2 μF and inductive loads of 0.1 H.

The device is specified to operate with a power supply range from ±12 V to ±24 V. Output loop compliance is 0 V to AVDD − 2.75 V.

The flexible serial interface is SPI- and MICROWIRE-compatible and can be operated in 3-wire mode to minimize the digital isolation required in isolated applications. The interface also features an optional PEC error checking feature using CRC-8 error checking, useful in industrial environments where data communication corruption can occur.

The device also includes a power-on-reset function, ensuring that the device powers up in a known state 0 V or tristate, and a asynchronous CLEAR pin that sets the outputs to zero scale/midscale voltage output or the low end of the selected current range.

An HW SELECT pin is used to configure the part for hardware or software mode on power-up.

Note that the plots in the Typical Performance Characteristics section of this data sheet contain information on the standard ranges, as released in the AD5750/AD5750-1 data sheet. Although the overranges have been tested, new plots were not generated and substitution data was used for plotting purposes.

**Applications**

.

Process control

.

Actuator control

.

PLCs

### Features and Benefits

.

Current output ranges:

4 mA to 21 mA, 0 mA to 21 mA

±0.15% FSR total unadjusted error TUE

±5 ppm/°C FSR typical output drift

.

Voltage output ranges: 0 V to 5 V,

0 V to 10.5 V, ±10.5 V

±0.05% FSR total unadjusted error TUE

±3 ppm/°C FSR output drift

.

Flexible serial digital interface

.

On-chip output fault detection

.

PEC error checking

.

Asynchronous CLEAR function

.

Flexible power-up condition to 0 V or tristate

.

Power supply range

AVDD: +12 V ± 10% to +24 V ± 10%

AVSS: −12 V ± 10% to −24 V ± 10%

.

Output loop compliance to

AVDD − 2.75 V

.

Temperature range: −40°C to +105°C

.

32-lead, 5 mm × 5 mm LFCSP package