TLE4998S8XUMA1
霍尔效应传感器, 线性, 5 mA, SOIC, 8 引脚, 4.5 V, 5.5 V
Description:
The linear Hall IC TLE4998S8 has been designed specifically to meet the requirements of highly accurate angle and position detection. The sensor provides a digital SENT signal based on the SAE J2716 standard, which consists of a sequence of pulses. Each transmission consists of multiple data nibbles containing the Hall value, the temperature and status information of the sensor. The output stage is an open-drain driver pulling the output pin to low only. Therefore, the high level needs to be obtained by an external pull-up resistor. This output type has the advantage that the receiver may use an even lower supply voltage e.g. 3.3 V. In this case the pull-up resistor must be connected to the given receiver supply.
Summary of Features:
- .
- Integration of two individual Linear Hall sensor IC’s with Single Edge Nibble Transmission SENT open-drain
- .
- output signal SAE J2716
- .
- 20-bit Digital Signal Processing DSP
- .
- Digital temperature and stress compensation
- .
- 16-bit overall resolution
- .
- Operating automotive temperature range -40°C to 125°C
- .
- Minimal drift of output signal over temperature and lifetime
- .
- Programmable parameters stored in EEPROM with single-bit error correction:
- .
- SENT unit time
- .
- Magnetic range, sensitivity gain, offset, and polarity of the output slope
- .
- Filter Bandwidth
- .
- Clamping levels�
- .
- Customer temperature compensation coefficients for all common magnets
- .
- Re-programmable until memory lock
- .
- Supply voltage 4.5-5.5 V 4.1-16 V extended range
- .
- Configurable magnetic range: ±50 mT, ±100 mT, or ±200 mT
- .
- Reverse-polarity and overvoltage protection for all pins
- .
- Output short-circuit protection
- .
- On-board diagnostics overvoltage, EEPROM error
- .
- Output of internal magnetic field values and temperature
- .
- Programming and operation of multiple sensors with common power supply
- .
- Two-point calibration of magnetic transfer function without iteration steps