TPS659122YFFR

专业电源管理 PMIC PMU for Processr Pwr

Description

The TPS659122 device provides four configurable step-down converters with up to 2.5A output current for memory, processor core, I/O, or pre-regulation of LDOs. It also contains 10 LDO regulators for external usage which can be supplied from either a battery or a pre-regulated supply. Power-up/power-down controller is configurable and can support any power-up/power-down sequences OTP based.

TPS659122 integrate a 32 kHz RC Oscillator to sequence all resources during Power up / down. All LDOs and DCDC converters can be controlled by I2C/SPI interface or Basic ENABLE Balls. In addition, an Independent automatic Voltage Scaling interface allows transitioning DCDC to different voltage by I2C or basic Roof/Floor Control. 3 RGB LED with advanced dimming feature are integrated inside the device.

Features

• 4 Step-Down Converters:

– VIN Range From 2.7V to 5.5V

– Power Save Mode at Light Load Current

– Output Voltage Accuracy in PWM Mode ±2%

– Typical 26 μA Quiescent Current per Converter

– Dynamic Voltage Scaling

– 100% Duty Cycle for Lowest Dropout

• 10 LDOs:

– 8 General Purpose LDOs

– Output Voltage Range 0.8V to 3.3V

– 2 Low Noise RF-LDOs

– Output Voltage Range 1.6V to 3.3V

– 32 μA Quiescent Current

– Pre-Regulation Support by Separate PowerInputs

– ECO mode

– VIN Range of LDOs:

• 1.8V to 3.6V or

• 3.0V to 5.5V, respectively

• 3 LED Outputs:

– Internal Dimming Using I2C

– Multiplexed with GPIOs

– Up to 20mA per Current Sink

• Thermal Monitoring

– High Temperature Warning

– Thermal Shutdown

• Bypass Switch

– Used with DCDC4 in Applications Powering an RF-PA

– As Supply Switch for e.g. SD cards

• Interface

– I2C Interface

– Power I2C Interface for Dynamic Voltage Scaling

– SPI

• 32kHz RC Oscillator

• Undervoltage Lockout and Battery Fault Comparator

• Long Button-Press Detection

• Flexible Power-Up and Power-Down Sequencing

• 3.6mm x 3.6mm WCSP Package with 0.4mm pitch

Applications

• Data cards

• Smartphones