SN74AVC8T245

具有可配置电压转换和三态输出的 8 位双电源总线收发器

This 8-bit noninverting bus transceiver uses two separate configurable power-supply rails. The is optimized to operate with VCCA/VCCB set at 1.4 V to 3.6 V. The device is operational with VCCA/VCCB as low as 1.2 V. The A port is designed to track VCCA. VCCA accepts any supply voltage from 1.2 V to 3.6 V. The B port is designed to track VCCB. VCCB accepts any supply voltage from 1.2 V to 3.6 V. This allows for universal low-voltage bidirectional translation between any of the 1.2-V, 1.5-V, 1.8-V, 2.5-V, and 3.3-V voltage nodes.

The SN74AVC8T245 is designed for asynchronous communication between data buses. The device transmits data from the A bus to the B bus or from the B bus to the A bus, depending on the logic level at the direction-control DIR input. The output-enable OE input can be used to disable the outputs so the buses are effectively isolated.

The SN74AVC8T245 is designed so the control pins DIR and OE are supplied by VCCA.

The SN74AVC8T245 solution is compatible with a single-supply system and can be replaced later with a ’245 function, with minimal printed circuit board redesign.

This device is fully specified for partial-power-down applications using Ioff. The Ioff circuitry disables the outputs, thus preventing damaging current backflow through the device when it is powered down.

The VCC isolation feature ensures that if either VCC input is at GND, both ports are in the high-impedance state.

To ensure the high-impedance state during power up or power down, OE shall be tied to VCC through a pullup resistor; the minimum value of the resistor is determined by the current-sinking capability of the

.

Control Inputs VIH/VIL Levels Are Referenced to VCCA Voltage

.

VCC Isolation Feature – If Either VCC Input Is at GND, All I/O

Ports Are in the High-Impedance State

.

Ioff Supports Partial Power-Down Mode Operation

.

Fully Configurable Dual-Rail Design Allows Each Port to Operate

Over the Full 1.4-V to 3.6-V Power-Supply Range

.

I/Os Are 4.6-V Tolerant

.

Maximum Data Rates

.

170 Mbps VCCA  < 1.8 V or VCCB  < 1.8 V

.

320 Mbps VCCA  ≥ 1.8 V and VCCB  ≥ 1.8 V

.

Latch-Up Performance Exceeds 100 mA Per JESD 78, Class II

.

ESD Protection Exceeds JESD 22

.

8000-V Human-Body Model A114-A

.

200-V Machine Model A115-A

.

1000-V Charged-Device Model C101