S6E2CC9J0AGV20000

Devices in the S6E2CC9J0A is highly integrated 32Bit microcontrollers with high performance and competitive cost. S6E2CC9J0A is based on the ARM Cortex-M4F processor with on-chip flash memory and SRAM. The series has peripherals such as motor control timers, A/D converters, and communications interfaces USB, CAN, UART, CSIO SPI, I2C, LIN

* 32-bit ARM Cortex-M4F Core * Processor version: r0p1 * Up to 200 MHz frequency operation * FPU built-in * Support DSP instructions * Memory protection unit MPU: improves the reliability of an embedded system * Integrated nested vectored interrupt controller NVIC: 1 NMI non-maskable interrupt and 128 peripheral interrupts and 16 priority levels * 24-bit system timer Sys Tick: system timer for OS task management * On-chip Memories * Flash memory * SRAM * External Bus Interface * Supports SRAM, NOR, NAND flash and SDRAM device * Up to 9 chip selects CS0 to CS8 CS8 is only for SDRAM * 8-/16-/32-bit data width * Up to 25-bit address bus * Supports address/data multiplexing * Supports external RDY function * Supports scramble function * USB Interface Max two channels * CAN Interface Max two channels * CAN-FD Interface One channel * Multi-function Serial Interface Max 16 Channels * DMA Controller Eight Channels * DSTC Descriptor System Data Transfer Controller; 256 channels * A/D Converter Max 32 Channels * D/A Converter Max two channels * Base Timer Max 16 channels * General Purpose I/O PortCapable of pull-up control per pin * Capable of reading pin level directly * Built-in port-relocate function * Up to 120 high-speed general-purpose I/O ports in 144-pin package * Some pins 5 V tolerant I/O * Multi-function Timer Max three units * Real-Time Clock RTC * Quadrature Position/Revolution Counter QPRC; Max four channels * Dual Timer 32-/16-bit Down Counter * Watch Counter * External Interrupt Controller Unit * Watchdog Timer Two channels * Cyclic Redundancy Check CRC Accelerator * Programmable Cyclic Redundancy Check PRGCRC Accelerator * SD Card Interface * Ethernet-MAC * Compliant with IEEE802.3 specification * 10 Mbps/100 Mbps data transfer rates supported * MII/RMII for external PHY device supported. * MII: Max one channel * RMII: Max one channel * Full-duplex and half-duplex mode supported. * Wake-ON-LAN supported * Built-in dedicated descriptor-system DMAC * Built-in 2 Kbytes transmit FIFO and 2 Kbytes receive FIFO. * Compliant IEEE1558-2008 PTP * I2S Inter-IC Sound Bus Interface TX x one channel, RX x one channel * High-speed Quad SPI * Clock and Reset * Clock Supervisor CSV * Low-Voltage Detector LVD * Low-power Consumption mode * Peripheral Clock Gating * VBAT