FT220XQ

FTDI  FT220XQ  接口, USB, 收发器, USB 2.0, 2.97 V, 5.5 V, QFN, 16 引脚

The is an USB 2.0 Full-speed IC, offers a compact bridge to 4-bit SPI/FT1248 interfaces. The device is a FT1248 slave, capable of operating up to 500kbps, with low power consumption 8mA. The IC includes the complete FT-X series feature set and enables USB to be added into a system design quickly and easily over an FT1248 interface.

.

FT1248 serial parallel interface in 1, 2 or 4-bit wide mode

.

Similar to an SPI slave in 1-bit mode

.

Entire USB protocol handled on chip, no USB specific firmware programming required

.

Fully integrated 2048-byte MTP memory for storing device descriptors and CBUS I/O configuration

.

Fully integrated clock generation with no external crystal required

.

Data transfer rates to 500kbps

.

512-byte receive buffer and 512-byte transmit buffer utilising buffer smoothing technology

.

FTDI"s royalty-free virtual com port VCP and direct D2XX drivers

.

Configurable CBUS I/O pin

.

Device supplied pre-programmed with unique USB serial number

.

Supports bus powered, self powered and high-power bus powered USB configurations

.

Integrated +3.3V level converter for USB I/O

.

True 3.3V CMOS drive output and TTL input operates down to 1V8 with external pull-ups

.

I/O levels from 1.8 to 3.3V 5V tolerant inputs

.

Configurable I/O pin output drive strength

.

Battery charger detection

.

Integrated power-on-reset circuit

.

Internal 3.3/1.8V LDO regulators

.

Low operating current of 8mA typical and USB suspend current of 125µA typical current

.

Low USB bandwidth consumption

ESD sensitive device, take proper precaution while handling the device.