MC9S08MP16VLFR

其他系列 51.34MHz 16K@x8bit 1KB

Overview

The S08MP16 is a cost-effective 8-bit MCU that delivers safe, accurate and inexpensive motor control for a wide range of industrial and automotive applications. An ideal entry-level solution for brushless DC BLDC motor applications, it features an 8-channel pulse width modulator PWM/flextimer module providing hardware dead-time insertion, analog comparators, programmable gain amplifier and a 12-bit analog-to-digital converter ADC with PWM hardware triggering. Also offered is an independently clocked COP and cyclic redundancy check CRC engine providing clock failure protection and memory content validation for safety-critical applications implementing IEC60730.

MoreLess

## Features

### S08 Central Processor Unit CPU

* Up to 50 MHz HCS08 CPU @ 2.7–5.5V across a temperature range of -40°C to +105°C

* HCS08 instruction set with added BGND instruction

### On-Chip Memory

* Up to 16 KB flash read/program/erase over full operating voltage and temperature range

* Up to 1 KB RAM

* Security circuitry to prevent unauthorized access to RAM and flash contents

### Power Saving Modes

* Two low-power Stop modes and reduced power Wait mode

* Peripheral clock gating can disable clocks to unused modules

### Peripherals

* Analog-to-digital converter ADC

* 13 channels

* 12-bit resolution

* 2.5 µs conversion time

* Automatic compare function

* 1.7 mV/°C temperature sensor

* Internal bandgap reference channel

* Operation in stop 3 mode

* 1 x 2-ch. FlexTimer + 1 x 6-ch

* Supports up to 51.34 MHz operation

* Selectable input capture

* Output compare

* Edgeor center-aligned PWM

* Dead time insertion

* Fault inputs

* MTIM: simple 8-bit timer with four software-selectable clock sources and a programmable interrupt

* 3 x high-speed analog comparators HSACMP

* +ve and -ve inputs

* Separately selectable interrupt on rising and falling comparator output

* Filtering

* Windowing

* HSCMP1 and HSCMP2 outputs can be optionally routed to FTM1 modul

* Runs in stop3

* Programmable gain amplifier PGA

* Differential programmable gain amplifier with programmable gain x1, x2, x4, x8, x16 or x32

* 2 x programmable delay blocks PDB

* PDB1 synchronizes PWM with samples of ADC

* PDB2 synchronizes PWM with comparing window of analog comparators

* Independently clocked COP and cyclic redundancy check generator

### Development Support

* Single-wire background debug interface

* Breakpoint capability

* ICE debug module

* Three comparators and nine trigger modes

* Eight deep FIFO for storing change-of-flow addresses and event-only data

* Supports both tag and force breakpoints

### Product Longevity Program

* This product is included in ®.s product longevity program, with assured supply for a minimum of 15 years after launch

* This product is included in NXP®.s product longevity program, with assured supply for a minimum of 15 years after launch