FT4232HQ-R
FTDI FT4232HQ-R 接口桥接器, USB 至 UART, MPSSE, 1.62 V, 1.98 V, QFN, 64 引脚, -40 °C
The is a 5th generation USB 2.0 High-speed 480Mbps to UART IC. It has the capability of being configured in a variety of industry standard serial or parallel interfaces. The IC features 4 UARTs. Two of these have an option to independently configure an MPSSE engine, this allows the IC to operate as two UART/bit-bang ports plus two MPSSE engines used to emulate JTAG, SPI, I²C, bit-bang or other synchronous serial modes.
- .
- Single chip USB to quad serial ports with a variety of configurations
- .
- Entire USB protocol handled on chip, no USB specific firmware programming required
- .
- USB 2.0 high-speed 480Mbps and full-speed 12Mbps compatible
- .
- Two multi-protocol synchronous serial engine MPSSE on channel A and channel B
- .
- Independent baud rate generators
- .
- RS232/RS422/RS485 UART transfer data rate up to 12Mbaud RS232 Data Rate Limited
- .
- FTDI"s royalty-free virtual com port VCP and direct D2XX drivers
- .
- Optional traffic TX/RX indicators can be added with LEDs and an external 74HC595 shift register
- .
- Adjustable receive buffer timeout
- .
- Support for USB suspend and resume conditions via PWREN#, SUSPEND# and RI# pins
- .
- Highly integrated design
- .
- FTDI FT232B style, asynchronous serial UART interface option
- .
- Fully assisted hardware or X-On/X-Off software handshaking
- .
- UART interface supports 7/8-bit data, 1/2 stop bits and odd/even/mark/space/no parity
- .
- Auto-transmit enable control for RS485 serial applications using TXDEN pin
- .
- Operational configuration mode and USB description strings configurable in external EEPROM over USB
- .
- Low operating and USB suspend current
- .
- Configurable I/O drive strength 4, 8, 12 or 16mA and slew rate
- .
- Supports bus powered, self powered and high-power bus powered USB configurations
- .
- UHCI/OHCI/EHCI host controller compatible
ESD sensitive device, take proper precaution while handling the device.