PN7360AUHN/C300E
芯片, 微控制器专用, PN7360系列, 12KB RAM, HVQFN-64
Overview
The PN7360 is a 32-bit ARM Cortex-M0-based NFC microcontrollers offering high performance and low power consumption. It has a simple instruction set and memory addressing along with a reduced code size compared to existing architectures. PN7360 offers all in one solutions, with features such as NFC, microcontroller and software in a single chipas well as 80 KB flash memory.
MoreLess
## Features
### Integrated contactless interface frontend
* High RF output power frontend IC for transfer speed up to 848 Kbit/s
* NFC IP1 and NFC IP2 support
* Full NFC tag support type 1, type 2, type 3, type 4 A and B
* P2P active and passive, target and initiator
* Card emulation ISO14443 type A
* ISO/IEC 14443 type A and type B
* MIFARE® classic card
* ISO/IEC 15693, and ISO/IEC 18000-3 mode 3
* Low-power card detection
* Dynamic Power Control DPC support
* Compliance with EMV contactless protocol specification
* Compliance with NFC standards
### Memory
* Flash: 80 KB
* SRAM: 12 KB
* EEPROM: 4 KB
* 40 KB boot ROM included, including USB mass storage primary bootloader for code download
### Performance
* * Processor core
* ARM Cortex: 32-bit M0 processor
* Built-in Nested Vectored Interrupt Controller NVIC
* Non-maskable interrupt
* 24-bit system tick timer
* Running frequency of up to 20 MHz
* Clock management to enable low power consumption
* Timers
* Four general-purpose timers
* Programmable WatchDog Timer WDT
* CRC coprocessor
* Random number generator
* Clocks
### Power & Temperature
* Two reduced power modes: standby mode and hard power-down mode
* Supports suspend mode for USB host interface
* Processor wake-up from hard power-down mode, standby mode, suspend mode via host interface, contact card interface, GPIOs, RF field detection
* Integrated PMU to adjust internal regulators automatically, to minimize the power consumption during all possible power modes
* Power-on reset
* RF supply: external, or using an integrated LDO TX LDO, configurable with 3 V, 3.3 V, 3.6 V, 4.5 V, and 4.75 V
* Pad voltage supply: external 3.3 V or 1.8 V, or using an integrated LDO 3.3 V supply
* Temperature range: -40 ℃ to +85 ℃
### Peripherals
* Host interface:
* USB 2.0 full speed with USB 3.0 hub connection capability
* HSUART for serial communication, supporting standards speeds from 9600 baud to 115200 baud, and faster speed up to 1.288 Mbit/s
* SPI with half duplex and full duplex capability with speeds up to 7 Mbit/s
* I²C supporting standard mode, fast mode and high-speed mode with multiple address support
* Master interface
* SPI with half duplex capability from 1 Mbit/s to 6.78 Mbit/s
* I²C supporting standard mode, fast mode, fast mode plus and clock stretching
### Interfaces
* Serial Wire Debug SWD interface
* Up to 21 General-Purpose I/O GPIO with configurable pull-up/pull-down resistors
* GPIO1 to GPIO12 can be used as edge and level sensitive interrupt sources
