EMLINK-AH

EMBEST  EMLINK-AH  适配器, JTAG, ARM EMLINK

The is a new generation high speed real time JTAG adapter, debugs the ARM Cortex-M3 processors through Keil Realview MDK and IAR EWARM. The EMLINK-AH connects the JTAG interface from target board ARM processors to PC USB port, supports source level debugging and flash programming. It has two sides, one is connected to PC through an USB port Host, another is JTAG port to connect to your target board"s JTAG port. Emlink can be powered supplied via PC"s USB port.

.

Supports ARM Cortex-M3 devices ST STM32, Luminary Stellaris, NXP LPC1700, Toshiba TMPM series etc

.

Download and debug speed up to 250KBytes/s

.

20pin JTAG interface convert to support 8 pin, 14 pin, does not support SWD

.

Wide target voltage range compatible: 3.3V to 5V

.

No power supply required

.

Easy to install using a single setup program

.

Integrates seamlessly into Keil Real View MDK and IAR Embedded Workbench

.

Single step execution supported

.

Supports hardware and software breakpoints