IL4118-X009

光电耦合器，光敏可控硅输出，零交叉，高dv / dt ，极低的输入电流 Optocoupler, Phototriac Output, Zero Crossing, High dV/dt, Very Low Input Current

* High input sensitivity: IFT = 1.3 mA, PF = 1.0; IFT = 3.5 mA, typical PF * Zero voltage crossing * 600 V, 700 V, and 800 V blocking voltage * 300 mA on-state current * High dV/dt 10 000 V/μs * Isolation test voltage 5300 VRMS * Very low leakage * Compliant to RoHS Directive 2002/95/EC and in accordance to WEEE 2002/96/EC

得捷:
OPTOISOLATOR 5.3KV TRIAC

贸泽:
三极与 SCR 输出光电耦合器 Phototriac Output Zero Crossing

艾睿:
Optocoupler Triac AC-OUT 1-CH 600VDRM 6-Pin PDIP SMD Tube

安富利:
The IL4116 consists of an AlGaAs IRLED optically coupled to a photosensitive zero crossing TRIAC network. The TRIAC consists of two inverse parallel connected monolithic SCRs. These three semiconductors devices are assembled in a six pin 300 mil dual in-line package.High input sensitivity is achieved by using an emitter follower phototransistor and a cascaded SCR predriver resulting in an LED trigger current of less than 1.3 mA DC.The IL4116 uses zero cross line voltage detection circuit witch consists of two enhancement MOSFETs and a photodiode. The inhibit voltage of the network is determined by the enhancement voltage of the n-channel FET.The P-channel FET is enabled by a photocurrent source that permits the FET to conduct the main voltage to gate on the n-channel FET. Once the main voltage can enable the n-channel, it clamps the base of the phototransistor, disabling the first stage SCR predriver.The blocking voltage of up to 800 V permits control of off-line voltages up to 240 VAC, with a safety factor of more than two, and is sufficient for as much as 380 VAC. Current handling capability is up to 300 mA RMS continuous at 25 °C.