TLC59116ITPWRQ1
LED照明驱动器 Automotive 16-Channel FM+ I2C-Bus Constant-Current LED Sink Driver 28-TSSOP -40 to 105
Description
The TLC59116-Q1 is an I2C-Bus controlled 16-channel LED driver that is optimized for red/green/blue/amber RGBA color mixing and backlight application. Each LED output has its own 8-bit resolution 256 steps fixed-frequency individual PWM controller that operates at 97-kHz, with a duty cycle that is adjustable from 0% to 99.6%.
Features
• 16 LED Drivers Each Output Programmable at Off, On, Programmable LED Brightness, or Programmable Group Dimming and Blinking Mixed With Individual LED Brightness
• 16 Constant-Current Output Channels
• 256-Step 8-Bit Linear Programmable Brightness Per LED Output Varying From Fully Off Default to Maximum Brightness Using a 97-kHz PWM Signal
• 256-Step Group Brightness Control Allows General Dimming [Using a 190-Hz PWM Signal From Fully Off to Maximum Brightness Default]
• 256-Step Group Blinking With Frequency Programmable From 24-Hz to 10.73 s and Duty Cycle From 0% to 99.6%
• Four Hardware Address Pins Allow 14 TLC59116-Q1 Devices to Be Connected to Same I2C Bus
• Four Software-Programmable I2C Bus Addresses One LED Group Call Address and Three LED Sub Call Addresses Allow Groups of Devices to Be Addressed at Same Time in Any Combination
• Software Reset Feature SWRST Call Allows Device to Be Reset Through I2C Bus
• Up to 14 Possible Hardware-Adjustable Individual I2C Bus Addresses Per Device, So That Each Device Can Be Programmed
• Open-Load and Overtemperature Detection Mode to Detect Individual LED Errors
• Output State Change Programmable on Acknowledge or Stop Command to Update Outputs Byte-by-Byte or All at Same Time Default to Change on Stop
• Output Current Adjusted Through an External Resistor
• Constant Output Current Range: 5-mA to 120-mA
• Maximum Output Voltage: 17 V
• 25-MHz Internal Oscillator Requires No External Components
• 1-MHz Fast-mode Plus FMT Compatible I2C-Bus Interface With 30-mA High-Drive Capability on SDA Output for Driving High-Capacitive Buses
• Internal Power-On Reset
• Noise Filter on SCL and SDA Inputs
• No Glitch on Power-Up
• Active-Low Reset
• Supports Hot Insertion
• Low Standby Current
Applications
• General LED Lighting Applications
• Backlight for center stack buttons
• Backlight for cluster indicators
