MC100EP90DTR2G

-3.3V / -5V三重ECL输入到LVPECL / PECL输出转换器 −3.3V / −5V Triple ECL Input to LVPECL/PECL Output Translator

The MC10/100EP90 is a TRIPLE ECL TO LVPECL/PECL translator. The device receives differential LVECL or ECL signals and translates them to differential LVPECL or PECL output signals. A V output is provided for interfacing with single ended LVECL or ECL signals at the input. If a single ended input is to be used the V output should be connected to the D input. The active signal would then drive the D input. When used the V output should be bypassed to ground by a 0.01 F capacitor. The V output is designed to act as the switching reference for the EP90 under single ended input switching conditions, as a result this pin can only source/sink up to 0.5mA of current. To accomplish the level translation the EP90 requires three power rails. The V supply should be connected to the positive supply, and the V connected to the negative supply. The 100 Series contains temperature compensation.

Features

---

 |

.

260 ps Typical Propagation Delay

.

Maximum Frequency > 3 GHz Typical

.

Voltage Supplies VCC = 3.0 V to 5.5 V, VEE = -3.0 V to -5.5 V, GND = 0 V

.

Open Input Default State

.

Safety Clamp on Inputs

.

Fully Differential Design

.

Q Output will default LOW with inputs open or at VEE

.

VBB Output

.

These are Pb-Free Devices