MSP430F6736IPNR
TEXAS INSTRUMENTS MSP430F6736IPNR 微控制器, 16位, 混合信号, MSP430F6xx, 25 MHz, 128 KB, 8 KB, 80 引脚, LQFP
The is a 16-bit ultra-low-power Mixed-signal Microcontroller features a powerful 16-bit RISC MSP430 CPU, 16-bit registers and constant generators that contribute to maximum code efficiency. The architecture combined with five low-power modes, is optimized to achieve extended battery life. The digitally controlled oscillator DCO allows wake-up from low-power modes to active mode in less than 3µs typical. The device configurations with four 16-bit timer, 10-bit A/D converter, three-channel internal DMA, four enhanced universal serial communication interfaces, a 32-bit hardware multiplier and 72 general-purpose I/O pins. This device operates at a maximum frequency of 25MHz.
- .
- 16-bit RISC architecture, extended memory, up to 25MHz system clock
- .
- Fully integrated LDO with programmable regulated core supply voltage
- .
- Supply voltage supervision, monitoring and brownout
- .
- FLL Control loop for frequency stabilization
- .
- Low-power low-frequency internal clock source VLO
- .
- Low-frequency trimmed internal reference source REFO
- .
- 32kHz Crystals XT1
- .
- High-frequency crystals up to 32MHz XT2
- .
- One 16-bit timer with three Capture/Compare registers
- .
- Three 16-bit timers with two Capture/Compare registers each
- .
- Enhanced UART supports auto-baudrate detection
- .
- IrDA Encoder and decoder
- .
- Synchronous SPI
- .
- Password-protected RTC with crystal offset calibration and temperature compensation
- .
- Separate voltage supply for backup subsystem
- .
- Three 24-bit sigma-delta ADC with differential PGA inputs
- .
- 10-bit ADC with internal shared reference, sample-and-hold and autoscan feature
- .
- Serial on-board programming, no external programming voltage needed
- .
- 265µA/MHz Active mode AM power consumption