ADL5365ACPZ-R7

1200 MHz至2500 MHz的平衡混频器， LO缓冲器和RF巴伦 1200 MHz to 2500 MHz Balanced Mixer, LO Buffer and RF Balun

Product Details

The ADL5365 uses a highly linear, doubly balanced passive mixer core along with integrated RF and LO balancing circuitry to allow for single-ended operation. The ADL5365 incorporates an RF balun, allowing for optimal performance over a 1200 MHz to 2500 MHz RF input frequency range using low-side LO injection for RF frequencies from 1700 MHz to 2500 MHz and high-side injection for frequencies from 1200 MHz to 1700 MHz. The balanced passive mixer arrangement provides good LO to RF leakage, typically better than −30 dBm, and excellent intermodulation performance. The balanced mixer core also provides extremely high input linearity, allowing the device to be used in demanding cellular applications where in-band blocking signals may otherwise result in the degradation of dynamic performance.

The ADL5365 provides two switched LO paths that can be used in test driven development TDD applications where it is desirable to rapidly switch between two local oscillators. LO current can be externally set using a resistor to minimize dc current commensurate with the desired level of performance. For low voltage applications, the ADL5365 is capable of operation at voltages down to 3.3 V with substantially reduced current. Under low voltage operation, an additional logic pin is provided to power down <200 µA the circuit when desired.

The ADL5365 is fabricated using a BiCMOS high performance IC process. The device is available in a 5 mm × 5 mm, 20-lead LFCSP, and operates over a −40°C to +85°C temperature range. An evaluation board is also available.

Applications

.

Cellular base station receivers

.

Transmit observation receivers

.

Radio link downconverters

### Features and Benefits

.

RF frequency range of 1200 MHz to 2500 MHz

.

IF frequency range of dc to 450 MHz

.

Power conversion loss: 7.3 dB

.

SSB noise figure of 8.3 dB

.

SSB noise figure with 5 dBm blocker of 18.5 dB

.

Input IP3 of 36 dBm

.

Typical LO drive of 0 dBm

.

Single-ended, 50 Ω RF and LO input ports

.

High isolation SPDT LO input switch

.

Single-supply operation: 3.3 V to 5 V

.

Exposed paddle 5 mm × 5 mm, 20-lead LFCSP

.

1500 V HBM/500 V FICDM ESD performance