65239-006LF
数据手册.pdf
Amphenol
安费诺
连接器
塑壳
The DUBOX 65239 series Connector families offer an extensive range of through-hole and surface-mount part options, including either straight or right angle orientation from 2 to 50 positions, with a current rating of 3A maximum per individual contact. The Dubox® contact has a pre-stressed, dual beam design to enable low insertion force, 4-wall contact design for signal protection. These are applicable in electronic equipment or devices requiring a parallel, planar or perpendicular board-to-board, wire to-board or flat cable interconnects. Uses span industry segments.
- .
- Dual beam contact design
- .
- Contact pre-stressed
- .
- Mates with very short pins 5mm stackable end-to-end and side-by-side
- .
- Floating solder tails self centre on the circuit pads
- .
- 4 wall contact design
- .
- Duplex plating
- .
- High reliable electrical performances
- .
- Low insertion force required
- .
- Meets your specific needs and is useful for Mezzanine Application
- .
- Easy to assures the coplanarity
- .
- Signal protection
- .
- Maintaining the alignment for soldering and facilitates robotic placement
- .
- Compatible with infrared and vaporphase reflow