UMFT201XB-NC
数据手册.pdf
FTDI Chip
飞特帝亚
主动器件
Interface Development Tools USB to I2C Dev BRD Breakout BRD FT201X
The is a Breakout Board with a low profile to convert USB to I²C with four control bus lines. This module converts USB2.0 full-speed to a serial interface and connects the serial signals to a 2.54mm 0.1" pitch 10-pin female receptacle. The boards do not use USB connector, but instead the modules plug directly into the USB host connector and the pads of the PCB makes electrical contact with the electrical contacts of the USB connector. All serial interfaces on these modules operate at 3.3V voltage levels, however all I/Os are 5V tolerant.
- .
- 3.3V Power out with a 50mA current limit and fused 5V
- .
- No connector option, no connector is fitted to CN2
- .
- Entire USB protocol handled on the chip. No USB specific firmware programming required
- .
- Royalty free VCP and D2XX drivers eliminate the requirement for USB driver development in most cases
- .
- Configurable CBUS I/O pin
- .
- Transmit and receive LED drive signals
- .
- Device supplied preprogrammed with unique USB serial number
- .
- Integrated power on reset circuit
- .
- UHCI/OHCI/EHCI host controller compatible
- .
- USB 2.0 Full Speed compatible