PIC18LF2539-I/SP

8位微控制器 -MCU 24KB 1408 RAM 21I/O

DEVICE OVERVIEW

This document contains device specific information for the following devices:

• PIC18F2439 • PIC18F4439

• PIC18F2539 • PIC18F4539

This family offers the advantages of all PIC18 microcontrollers - namely, high computational performance

at an economical price - with the addition of high-endurance Enhanced FLASH program memory. The PIC18FXX39 family also provides an off-the-shelf solution for simple motor control applications, allowing users to create speed control solutions with small part counts and short development times.

High Performance RISC CPU:

• Linear program memory addressing to 24 Kbytes

• Linear data memory addressing to 1.4 Kbytes

• 20 MHz operation 5 MIPs:

\- 20 MHz oscillator/clock input

\- 5 MHz oscillator/clock input with PLL active

• 16-bit wide instructions, 8-bit wide data path

• 8 x 8 Single Cycle Hardware Multiplier

Special Microcontroller Features:

• 100,000 erase/write cycle Enhanced FLASH program memory typical

• 1,000,000 erase/write cycle Data EEPROM memory

• FLASH/Data EEPROM Retention: > 100 years

• Power-on Reset POR, Power-up Timer PWRT and Oscillator Start-up Timer OST

• Programmable code protection

• Power saving SLEEP mode

• Single supply 5V In-Circuit Serial Programming™ ICSP™ via two pins

• In-Circuit Debug ICD via two pins

Analog Features:

• Compatible 10-bit Analog-to-Digital Converter module A/D with:

\- Fast sampling rate

\- Conversion available during SLEEP

\- DNL = ±1 LSb, INL = ±1 LSb

• Programmable Low Voltage Detection PLVD

\- Supports interrupt on Low Voltage Detection

• Programmable Brown-out Reset BOR

Peripheral Features:

• High current sink/source 25 mA/25 mA

• Three external interrupt pins

• Timer0 module: 8-bit/16-bit timer/counter with 8-bit programmable prescaler

• Timer1 module: 16-bit timer/counter

• Timer3 module: 16-bit timer/counter

• Secondary oscillator clock option - Timer1/Timer3

• Two PWM modules:

\- Resolution is 1- to 10-bit, Max. PWM freq. @ 8-bit resolution = 156 kHz 10-bit resolution = 39 kHz

• Single Phase Induction Motor Control kernel

\- Programmable Motor Control Technology ProMPT™ provides open loop Variable Frequency VF control

\- User programmable Voltage vs. Frequency curve

\- Most suitable for shaded pole and permanent split capacitor type motors

• Master Synchronous Serial Port MSSP module with two modes of operation:

\- 3-wire SPI supports all 4 SPI modes

-I2C™ Master and Slave mode

• Addressable USART module:

\- Supports RS-485 and RS-232

• Parallel Slave Port PSP module

CMOS Technology:

• Low power, high speed FLASH/EEPROM technology

• Fully static design

• Wide operating voltage range 2.0V to 5.5V

• Industrial and Extended temperature ranges