MC9S08SH8MTJ

NXP  MC9S08SH8MTJ  微控制器, 8位, 通用 SH系列, S08SH, 40 MHz, 8 KB, 512 Byte, 20 引脚, TSSOP

The is a 8-bit General-purpose Microcontroller based on enhanced HCS08 CPU 20MHz bus with CISC architecture operates at a maximum frequency of 40MHz. The device incorporates 8kB internal flash, 0.512kB internal RAM, an analog comparator, 12-channel 10-bit A/D converter and 17 general-purpose I/O pins. This device also features peripherals like one inter-integrated circuit IIC bus module to operate at up to 100kbps, one serial peripheral interface modules SPI and one serial communications interface SCI module.

.

HC08 Instruction set with added BGND instruction

.

Support for up to 32 Interrupt/reset sources

.

Two very low power stop modes

.

Reduced power wait mode

.

Very low power real time interrupt for use in run, wait and stop

.

Loop-control Pierce oscillator XOSC

.

Internal clock source ICS

.

Watchdog computer operating properly COP reset

.

Low-voltage detection with reset or interrupt - selectable trip points

.

Illegal opcode detection with reset

.

Illegal address detection with reset

.

Flash block protect

.

8-bit Modulo counter with 8-bit prescaler and overflow interrupt

.

Two 2-channel Timer PWM modules TPM1, TPM2

.

8 Interrupt pins with selectable polarity

.

Hysteresis and configurable pull up device on all input pins

.

Configurable slew rate and drive strength on all output pins

.

Single-wire background debug interface

.

Breakpoint capability to allow single breakpoint setting during in-circuit debugging

.

In-circuit emulation ICE debug module