MAX13450EAUD+

RS - 485收发器，集成100Ω / 120Ω终端电阻 RS-485 Transceivers with Integrated 100Ω/120Ω Termination Resistors

The is a full duplex RS485 transceiver with integrated 100 ohm/120 ohm termination resistors in 14 pin TSSOP package. This device has one RS485 transmitter and one RS485 receiver. The resistor values are pin selectable. A logic supply input allows interfacing to logic levels down to +1.8V. The MAX13450E has strong drivers specified to drive low impedance lines found when fully loaded bus based on today"s 100 ohm characteristic impedance cable is double terminated. It allows slew rate limiting of driver output to reduce EMI and reflections for data rates up to 500Kbps. The device also has 1/8 unit load receiver input impedance which allows up to 256 transceivers on the bus. All driver outputs are ESD protected to ±30KV human body model, ±15KV air gap discharge per IEC 61000-4-2, ±7KV contact discharge per IEC 61000-4-2.

.

Supply voltage range is 4.5V to 5.5V

.

Automotive temperature range from -40°C to 125°C

.

Easy configuration of RS422 and RS485 networks up to 20Mbps data rate

.

Software/pin selectable termination eliminates need for external resistors and DIP switches

.

Designed to perform in harsh environments, supports Cat-5/Cat-6 and 24AWG cables

.

Supply current of 6mA DE = active-low RE = high, active-low TERM = high, no load

.

Integrated low voltage logic down to 1.8V interfaces with small geometry ASICs and FPGA

.

Thermal and overcurrent protection

.

Fail-safe receivers