LPC1113FHN33/302,5

NXP  LPC1113FHN33/302,5  微控制器, 32位, ARM 皮质-M0, 50 MHz, 24 KB, 8 KB, 33 引脚, HVQFN

Overview

The LPC1113FHN33 is an ARM Cortex-M0 microcontroller and it can operate up to 50 MHz. The peripheral complement of the LPC1113FHN33 includes 24 kB of flash memory, up to 8 kB of data memory, one Fast-mode Plus I²C-bus interface, one RS-485/EIA-485 UART, one SPI interface with SSP features, four general purpose counter/timers, a 10-bit ADC, and 28 general purpose I/O pins. In addition, the LPC1113FHN33 features unique on-chip API-driven power profiles which provide users with ready-to-use power management templates. Optimized for CPU performance, CPU efficiency and lowest active current, the power profiles enable maximum operating frequency through the entire voltage range from 1.8 V to 3.6 V without compromising speed or functionality.

MoreLess

## Features

* ARM Cortex-M0 processor, running at frequencies of up to 50 MHz

* ARM Cortex-M0 built-in Nested Vectored Interrupt Controller NVIC

* Serial Wire Debug

* System tick timer

* 24 kB on-chip flash programming memory

* 8 kB SRAM LPC1113FHN33/30x

* 4 kB SRAM LPC1113FHN33/20x

* In-System Programming ISP and In-Application Programming IAP

* 28 General Purpose I/O GPIO pins with configurable pull-up/-down resistors

* High-current output driver 20 mA on one pin

* Programmable WatchDog Timer WDT

* 10-bit ADC with input multiplexing among 8 pins

* UART with fractional baud rate generation

* One SPI controller with SSP features and FIFO and multi-protocol capabilities

* I²C-bus interface supporting full I²C-bus specification and Fast-mode Plus

* Integrated PMU Power Management Unit to minimize power consumption

* Power profiles residing in boot ROM LPC1100Land LPC1100XL series only

* Unique device serial number for identification

* Single 3.3 V power supply 1.8 V to 3.6 V

## Target Applications

* eMetering

* Alarm systems

* Lighting

* White goods

## Features