ATMEGA3290A-AU

ATMEL  ATMEGA3290A-AU  微控制器, 8位, 低功率高性能, ATmega, 20 MHz, 32 KB, 2 KB, 100 引脚, TQFP

The is a high-performance, low-power 8-bit AVR RISC-based Microcontroller combines 32kB ISP flash memory with read-while-write capabilities, 1kB EEPROM, 2kB SRAM, 54/69 general purpose I/O lines, 32 general purpose working registers, a JTAG interface for boundary-scan and on-chip debugging/programming, a complete on-chip LCD controller with internal contrast control, three flexible timers/counters with compare modes, internal and external interrupts, serial programmable USART, an universal serial interface USI with start condition detector, an 8-channel 10-bit A/D converter, programmable watchdog timer with internal oscillator, SPI serial port and five software selectable power saving modes. The device operates between 1.8 to 5.5V. By executing powerful instructions in a single clock cycle, the device achieves throughputs approaching 1MIPS per MHz, balancing power consumption and processing speed.

.

Advanced RISC architecture

.

Power-on reset and programmable brown-out detection

.

Internal calibrated RC oscillator

.

External and internal interrupt sources

.

Five sleep modes - Idle, ADC noise reduction, power-save, power-down and standby

.

130 Powerful instructions-most single clock cycle execution

.

32 x 8 General purpose working registers

.

Fully static operation

.

Up to 20MIPS throughput at 20MHz

.

On-chip 2-cycle multiplier

.

QTouch® library support

.

JTAG IEEE std. 1149.1 compliant interface

.

Programmable watchdog timer with separate on-chip oscillator

.

On-chip analog comparator

.

Interrupt and wake-up on pin change

.

Real-time counter with separate oscillator

.

Four PWM channels

.

Programmable serial USART

.

Master/Slave SPI serial interface

.

Universal serial interface with start condition detector